| Brand | GM Genuine Parts |
| Bleeder Hoses Included | No |
| Brake Booster Included | No |
| Brake Pressure Switch(s) Included | No |
| Dust Boot Included | No |
| Features & Benefits - Bullet 1 | Pressure tested to ensure safe and confident braking |
| Features & Benefits - Bullet 2 | Meets the brake performance requirements of SAE J1153 and J1154 testing, providing reliability and quality |
| Features & Benefits - Bullet 3 | GM-recommended replacement part for your GM vehicle's original factory component |
| Features & Benefits - Bullet 4 | Offering the quality, reliability, and durability of GM OE |
| Features & Benefits - Bullet 5 | Manufactured with GM Original Equipment specification for fit, form, and function |
| Gasket Or Seal Included | Yes |
| Good Maintenance Practices - Section 1 - Bullet 1 | Check brake fluid level at every oil change. Replace fluid according to owner's manual recommendations. |
| Good Maintenance Practices - Section 1 - Bullet 2 | Calipers and wheel cylinders should be checked every brake inspection and serviced or replaced as required. |
| Good Maintenance Practices - Section 1 - Bullet 3 | Inspect the brake lines for rust, punctures, or visible leaks (You may be able to do this, but consult a qualified technician if necessary). |
| Good Maintenance Practices - Section 1 - Bullet 4 | Check the thickness of your brake pads. |
| Good Maintenance Practices - Section 1 - Header | The following inspections and maintenance procedures can help prevent potential brake problems. |
| Good Maintenance Practices - Section 2 - Bullet 1 | Inspection of the brake hoses for brittleness or cracking. |
| Good Maintenance Practices - Section 2 - Bullet 2 | Inspection of brake lining and pads for wear or contamination by brake fluid or grease. |
| Good Maintenance Practices - Section 2 - Bullet 3 | Inspection of wheel bearings and grease seals. |
| Good Maintenance Practices - Section 2 - Bullet 4 | Parking brake adjustments (as needed). |
| Good Maintenance Practices - Section 2 - Header | The following should be conducted by a qualified technician: |
| Height (in) | 7.25 |
| Length (in) | 11.25 |
| Master Cylinder Bore Diameter | 1.48 |
| Master Cylinder Cap Included | Yes |
| Mounting Bracket Included | No |
| Mounting Hardware Included | No |
| Mounting Hole Quantity | 2 |
| PADB ID 7322 | 0.49 |
| PADB ID 7451 | 0.49 |
| Pedal Rod ID | No |
| Piston Quantity | 1 |
| Port Quantity | 2 |
| Programming Required | No |
| Push Rod Included | No |
| Reservoir Included | Yes |
| Reservoir Material | Plastic |
| Reservoir Style | Removable |
| Reservoir Type | Single |
| Sensor Included | Yes |
| Signs of Wear & Troubleshooting - Section 1 - Bullet 1 | Brake warning light is on. |
| Signs of Wear & Troubleshooting - Section 1 - Bullet 2 | Fluid spots beneath the car, indicating there may be a leak within the cylinder. |
| Signs of Wear & Troubleshooting - Section 1 - Bullet 3 | Difficulty stopping the vehicle. |
| Signs of Wear & Troubleshooting - Section 1 - Bullet 4 | A low or sinking brake pedal. |
| Signs of Wear & Troubleshooting - Section 1 - Header | Brake cylinder signs of wear include: |
| Weight (lb) | 3.54 |
| Width (in) | 10.5 |
WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov 