| Brand | GM Genuine Parts |
| Connector Gender | Female |
| Connector Quantity | 1 |
| Features & Benefits - Bullet 1 | This part requires programming and/or special setup procedures. GM Service Information describes the procedures and special tools needed to ensure proper operation in the vehicle |
| Features & Benefits - Bullet 2 | Helps enhance braking ability |
| Features & Benefits - Bullet 3 | Helps control the wheels in inclement weather |
| Features & Benefits - Bullet 4 | Some ACDelco GM Original Equipment parts may have formerly appeared as GM Genuine Parts (OE) or ACDelco Professional |
| Features & Benefits - Bullet 5 | ACDelco GM Original Equipment parts are designed, engineered and tested to rigorous standards, and are backed by General Motors. |
| Features & Benefits - Bullet 6 | GM Engineers design and validate OE parts specifically for your Chevrolet, Buick, GMC, or Cadillac vehicle |
| Features & Benefits - Bullet 7 | GM regularly updates production and service part designs to integrate new materials and technologies |
| Good Maintenance Practices - Section 1 - Bullet 1 | Check brake fluid level at every oil change. Replace fluid according to owner's manual recommendations. |
| Good Maintenance Practices - Section 1 - Bullet 2 | Calipers and wheel cylinders should be checked every brake inspection and serviced or replaced as required. |
| Good Maintenance Practices - Section 1 - Bullet 3 | Inspect the brake lines for rust, punctures, or visible leaks (You may be able to do this, but consult a qualified technician if necessary). |
| Good Maintenance Practices - Section 1 - Bullet 4 | Check the thickness of your brake pads. |
| Good Maintenance Practices - Section 1 - Header | The following inspections and maintenance procedures can help prevent potential brake problems. |
| Good Maintenance Practices - Section 2 - Bullet 1 | Inspection of the brake hoses for brittleness or cracking. |
| Good Maintenance Practices - Section 2 - Bullet 2 | Inspection of brake lining and pads for wear or contamination by brake fluid or grease. |
| Good Maintenance Practices - Section 2 - Bullet 3 | Inspection of wheel bearings and grease seals. |
| Good Maintenance Practices - Section 2 - Bullet 4 | Parking brake adjustments (as needed). |
| Good Maintenance Practices - Section 2 - Header | The following should be conducted by a qualified technician: |
| Mounting Hardware Included | Yes |
| Programming Required | Yes |
| Signs of Wear & Troubleshooting - Section 1 - Bullet 1 | Chirping or grinding noises when braking. |
| Signs of Wear & Troubleshooting - Section 1 - Bullet 2 | Difficulty stopping the vehicle. |
| Signs of Wear & Troubleshooting - Section 1 - Bullet 3 | A low or sinking brake pedal. |
| Signs of Wear & Troubleshooting - Section 1 - Bullet 4 | Brake pedal pulsation (not to be confused with normal ABS operation). |
| Signs of Wear & Troubleshooting - Section 1 - Bullet 5 | Vehicle pulls to the left or right when brakes are applied. |
| Signs of Wear & Troubleshooting - Section 1 - Header | General brake signs of wear include: |
WARNING: Cancer and reproductive harm - www.P65Warnings.ca.gov 